Bruker manual PHILIPS FW339C

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] TM All available radio stations with sufficient signal strength will be stored or until 40 presets are filled. 2 The system will search once again for the first available RDS station and to set the RDS time automatically. · When searching RDS station; TM "SEARCH RDS STATION" will be displayed. If no RDS station is available, the program will exit automatically and "NO RDS STATION" will be displayed. TM After a station is found, "EASY SET" will be displayed and followed by "TIME". · When searching RDS time; TM "SEARCH RDS TIME" will be displayed. TM When RDS time is read, "RDS TIME" will be displayed. The current time is displayed for 2 seconds and will be stored automatically. Notes : ­ When EASY SET is used, all previously stored radio stations will be erased. Untitled-1 14 v v v v v NEXT 6/15/00, 2:04 PM 3139 116 19271 TUNER You can store up to 40 radio stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press PROGRAM for more than one second. TM PROGRAM flag starts flashing and `AUTO' will be displayed. (middle of the road music), Light M, Classics, Other M, No type. · RADIO TEXT (RT): text messages appear in the display. Note: ­ When you press the RDS button and the display shows "NO RDS", it indicates that either the tuned station is not transmitting RDS signal or it is a non RDS station. RDS Time Some RDS station may be transmitting a real time clock at an interval of every minute. Setting the time with RDS clock 1 Press CLOCK/TIMER. TM "--:--" or current time appears on the display. 2 Press CLOCK/TIMER once more to enter clock setting mode. TM "00:00" or current time starts flashing. TM The message "SEARCH RDS TIME" will be displayed. Notes: ­ You can cancel the automatic programming by pressing PROGRAM or STOP·CLEAR Ç on the system only. Notes: ­ When 40 radio stations are stored and you attempt to store another radio station, the display will show " PROGRAM FULL". If you want to change an existing preset number; repeat steps 4 and 5. Untitled-1 15 6/15/00, 2:04 PM 3139 116 19271 TUNER TM If the station does not transmit RDS clock, "NO RDS TIME" will be displayed. TM When the RDS clock is read, "RDS TIME" will be displayed. The current clock time is displayed for 2 seconds and will be stored automatically. TM If within 90 seconds, the RDS time is not detected, "NO RDS TIME" will be displayed. [. . . ] TM Stop the recording or wait until it is finished. "TAPE DUBBING ONLY" is displayed. · Tape dubbing is only possible in tape mode. Recording or playback cannot be made or there is a decrease in audio level. [. . . ]