Bruker manual PHILIPS FW-M355

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] TM "PROGRAM CLEARED" will be displayed. Note: ­ The program will be erased when the system is disconnected from the power supply, the system is switched to standby mode, when you change source or when you change the program disc. Notes: ­ "A" represents ALBUM and "T" represents TITLE, "XX" or "XXX" is the current selected Album or Title number. FWM55-22-GB-ENG-V01 15 12/8/00, 1:57 PM 3139 115 20071 English 15 Playing the program Repeat (only on remote control) MP3 Disc ­ The ALBUM and TITLE will only be displayed once when selected. To view the selected ALBUM or TITLE again, press the respective DISPLAY button on the remote control. TUNER Storing Preset Stations MINI HIFI SYSTEM PROGRAM SHUFFLE REPEAT TIMER REC NEWS T. A. AM MW FM LW 60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz STEREO BACK FRONT HSD STANDBY ON RDS You can store up to 40 radio stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display. Automatic programming 1 Press TUNER (BAND). TM The PROGRAM starts flashing and "AUTO" will be displayed. TM The system will start searching for all radio stations with RDS and then followed by radio stations on FM, MW and LW band respectively. TM All available stations will be stored automatically. The frequency and preset number will be displayed briefly. TM The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. When you have tuned to a RDS station, the RDS logo (Ç) and the radio station name will appear on the display: · The display normally shows the radio station name if available. By repeatedly pressing RDS button you can change the type of display information: TM The display shows in turn: STATION NAME TM PROGRAM TYPE TM RADIO TEXT TM TUNED FREQUENCY TM STATION NAME . . . Note: ­ When you press the RDS button and the display shows "NO RDS", it indicates that either the tuned station is not transmitting RDS signal or it is a non RDS station. RDS Clock Some RDS station may be transmitting a real clock time at an interval of every minute. Setting the time with RDS clock 1 Press CLOCK/TIMER. TM "--:--" or current time appears on the display. 2 Press CLOCK/TIMER once more to enter clock setting mode. TM "00:00" or current time starts flashing. TM The message "SEARCH RDS TIME" will be displayed. TM If the station does not transmit RDS clock, "NO RDS TIME" will be displayed. TM When the RDS clock is read, "RDS TIME" will be displayed. The current clock time is displayed for 2 seconds and will be stored automatically. TM If within 90 seconds, the RDS time is not detected, "NO RDS TIME" will be displayed. Note: ­ Some RDS station may be transmitting a real time clock at a minute interval. [. . . ] TM See section on tape deck maintenance (page 25). · Magnetic build-up in the record/ playback head. · Power failure or AC power plug disconnect from the wall outlet during tape playback. TM Reconnect the AC power plug and switch on the system again. General System does not react when any button is pressed. [. . . ]