Bruker manual PHILIPS FW-C115

[. . . ] Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] 6 Press Ç once to end programming. The total number of tracks programmed and total playing time appear on the display. Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" appears on the display instead of the total playing time. ­ If the system is reading the discs, programming is not possible, "READING" will be displayed and followed by "DISC X". "X" is the current read disc number. ­ During programming, if no button is pressed within 20 seconds, the system will exit programme mode automatically. ­ "SELECT A DISC" will be displayed when programming an empty disc slot. Disc Change You can change the outer two discs while the third inner disc is stopped or is playing. 1 Press DISC CHANGE. 2 Replace the discs in the left and right disc trays. ¶ If you wish to change the inner disc during playback, press DISC CHANGE again. "DISC CHANGE" will be displayed. The CD changer tray will close to retrieve the inner disc and then open again with the inner disc accessible. Notes: ­ If you press any of the DISC DIRECT PLAY buttons, the system will play the selected disc and the stored programme will be ignored temporarily. The PROG display also will disappear temporarily from the display. It will reappear when playback of the selected disc ends. ­ REPEAT DISC mode will be cancelled when programme playback begins. 1 Note: ­ REPEAT DISC mode will be cancelled when shuffle is selected. Repeat (only on remote control) You can play the current track, a disc or all available discs repeatedly. Press REPEAT on the remote control to select the various repeat modes. "TRACK", "DISC", "ALL DISC" or "OFF" will be displayed. ¶ The selected track, selected disc or all available discs will now be played repeatedly until you pressÇ. 2 Press REPEAT until the "OFF" mode is displayed to resume normal playback. The REP flag disappears from the display. Notes: ­ REPEAT DISC mode is not available during programme play or shuffle mode. ­ You can also repeat shuffling a programme. [. . . ] ¶ You can also clean the heads by playing a cleaning tape once. Demagnetizing the heads ¶ Use a demagnetizing tape available at your dealer. Troubleshooting WARNING Do not open the player as there is a risk of electric shock!Under no circumstances should you try to repair the player yourself, as this will invalidate the warranty If a fault occurs, first check the points listed below before taking the player for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Symptom "NO DISC" is displayed. [. . . ]