Bruker manual PHILIPS AJ3980

[. . . ] SETTING THE CLOCK TIME (see figure 3) The time is displayed using the 24 hour clock. In the standby mode, press TIME SET to activate the clock setting mode. =The current clock time in the main display flashes. Press HOUR / MINUTE to adjust the hours and minutes respectively. [. . . ] radio alarm : make sure you have tuned properly to a station. SELECTING CD WAKE-UP ALARM MODE You can program and select a CD track number between 1-99, when the set is in the standby or radio playback mode. However, if the track number programmed does not exist on your CD, the CD will start playback from the first track during the alarm call. Press WAKE-UP TRACK to activate favorite track programming. Press or until the desired track number is shown. Press WAKE-UP TRACK to confirm the selected track number. = The display returns to standby clock time. If you want to review your programmed track number, press WAKE-UP TRACK. CD Helpful Tip During an alarm call/ repeat alarm, only the DAILY ALARM RESET, REPEAT ALARM/ BRIGHTNESS CONTROL and ALARM 1 or ALARM 2 and + / VOLUME controls on the set will operate. DAILY ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · Press and hold DAILY ALARM RESET =You will hear a beep tone to confirm that the alarm reset has been activated. REPEAT ALARM This will repeat your alarm call at 9 minute intervals. · During the alarm call, press REPEAT ALARM/ BRIGHTNESS CONTROL. CD / RADIO 5. Or press TIME / ALARM CD / RADIO OFF to return to standby mode. Helpful Tip : In the CD stop position, the CD touch screen display remains active for 5 minutes. · Press to start playback again if you have stopped briefly e. g. to change a CD. To improve reception : FM : extend the coil antenna fully at the back of the set for optimum reception. Direct the antenna by adjusting the position of your set. Adjust the sound using the + / - VOLUME. To switch off the radio, press the TIME/ALARM CD / RADIO OFF button. TUNING TO A STATION (see figure 6) ­ If CD playback is paused for more than 15 minutes and no controls are pressed, the set automatically goes to standby mode. SELECTING A DIFFERENT TRACK DURING PLAYBACK The track number appears briefly in the display when to skip tracks. you press or · Press · Press once or more to skip to the next track(s). more than once to skip to previous tracks · Repeat as often as desired. , , = Your alarm mode indication will flash throughout the time the repeat alarm is active. CANCELLING THE ALARM COMPLETELY When an alarm is cancelled this is shown by the selected alarm indication and symbol disappearing from the display. To cancel the set alarm time before it goes off: · Press ALARM 1 or ALARM 2 until the alarm icons / / disappears from the display. CD PLAYBACK (see figure 5) 1. Insert a CD with the printed side facing up, and close the door. =Display shows: 'Cd: --' and the total number of tracks, then your current track number, before returning to clock time =CD touch screen controls appears throughout CD operation. Other possible CD indications before returning to clock time: =door is shown if the CD door is not closed. [. . . ] - Connect the brown wire to the terminal marked L or coloured red. - Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Recording and playback of material may require consent. [. . . ]