Bruker manual HUSQVARNA HECTH210KA

[. . . ] See instructions under the heading Technical Data for a list of replacement bar and chain combinations we recommend. The number of drive links is determined by the length of the bar, the chain pitch and the number of teeth on the bar tip sprocket. See instructions under the heading Technical data for information about sharpening your chain. See instructions under the heading Technical data for information on the size of file and gauge that are recommended for the chain fitted to your chain saw. [. . . ] See instructions under the heading Lubricating the bar tip sprocket. Checking wear on cutting equipment • To prolong the life of the bar you should turn it over regularly. The chain is correctly tensioned when there is no slack on the underside of the bar, and it can still be turned easily by hand. 1 2008-03-26 English – 17 ASSEMBLY Fit the bar over the bar bolts. The chain is correctly tensioned when it does not sag from the underside of the bar, but can still be turned easily by hand. Hold up the bar tip and tighten the bar knob by turning the knob clockwise. If the machine is not used for some time the fuel tank should be emptied and cleaned. € • • • • Environment fuel HUSQVARNA recommends the use of alkylate fuel or environmental fuel for four-stroke engines blended with two-stroke oil as set out below. Note that carburetor adjustment may be necessary when changing the type of fuel (see instructions under the heading Carburetor). 1 2008-03-26 English – 39 TECHNICAL DATA Recommended original and replacement bar and chain combinations Following is a list of recommended cutting equipment for the Husqvarna chain saw models 435, 435e and 440e. As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. for guide bars of the same length , all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar. WARRANTY PERIOD Any warranted part that is scheduled for replacement as required in the maintenance schedule, is warranted for the period of time prior to the first scheduled replacement point for that part. if the part fails prior to the first scheduled replacement , the part will be repaired or replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under warranty is warranted for the remainder of the period prior to the first scheduled replacement point for the part. Any warranted part that is not scheduled for replacement as required in the maintenance schedule, is warranted for two years. if any such part fails during the period of warranty coverage , it will be repaired and replaced by Husqvarna Forest & Garden at no cost. [. . . ] if any such part fails during the period of warranty coverage , it will be repaired and replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under the warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the maintenance schedule will be warranted for a period of two years. a statement in such written instructions to the effect of ”repair or replace as necessary” will not reduce the period of warranty coverage. [. . . ]