Bruker manual HUSQVARNA HECTH180KE

[. . . ] (32) The chain is correctly tensioned when it does not sag from the underside of the bar, but can still be turned easily by hand. Hold up the bar tip and tighten the bar knob by turning the knob clockwise. Two-stroke oil • For best results and performance use HUSQVARNA two-stroke engine oil, which is specially formulated for our air-cooled two stroke-engines. If the machine is not used for some time the fuel tank should be emptied and cleaned. [. . . ] € Environment fuel HUSQVARNA recommends the use of alkylate fuel or environmental fuel for four-stroke engines blended with two-stroke oil as set out below. Note that carburetor adjustment may be necessary when changing the type of fuel (see instructions under the heading Carburetor). Running-in Avoid running at a too high speed for extended periods during the first 10 hours. Always store fuel in an approved container designed for that purpose. For longer periods of storage or for transport of the chain saw, the fuel and chain oil tanks should be emptied. Push down the red choke control, 5: As soon as the engine fires which can be heard through a "puff" sound, push down on the red choke control. Start position, 1: The correct choke/start throttle setting for warm starting is obtained by initially moving the choke control by pulling the red control outward - upwards. (47) 445e TrioBrake Start position, 1: The correct choke/start throttle setting for warm starting is obtained by initially moving the choke control by pulling the red control outward - upwards. Push down the red choke control, 4: As soon as the engine fires which can be heard through a "puff" sound, push down on the red choke control. if the part fails prior to the first scheduled replacement , the part will be repaired or replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under warranty is warranted for the remainder of the period prior to the first scheduled replacement point for the part. Any warranted part that is not scheduled for replacement as required in the maintenance schedule, is warranted for two years. if any such part fails during the period of warranty coverage , it will be repaired and replaced by Husqvarna Forest & Garden at no cost. Any such part repaired or replaced under the warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the maintenance schedule will be warranted for a period of two years. a statement in such written instructions to the effect of ”repair or replace as necessary” will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period. dIAGNOSIS The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact defective , provided that such diagnostic work is performed at a warranty station. [. . . ] Any such part repaired or replaced under warranty will be warranted for the remaining warranty period. dIAGNOSIS The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact defective , provided that such diagnostic work is performed at a warranty station. CONSEQUENTIAL DAMAGES Husqvarna Forest & Garden is liable for damages to other engine components proximately caused by a failure under warranty of any warranted part. Husqvarna Forest & Garden must warrant the emission control system on your small nonroad engine for the period of time listed below provided there has been no abuse, neglect or improper maintenance of your unit. [. . . ]