Bruker manual HUSQVARNA HECTH150KA

[. . . ] See instructions under the heading Technical data for information about sharpening your chain. Some terms that describe the bar and chain To maintain the safety features of the cutting equipment, you should replace a worn or damaged bar or chain with a bar and chain combinations recommended by Husqvarna. See instructions under the heading Technical Data for a list of replacement bar and chain combinations we recommend. [. . . ] The number of drive links is determined by the length of the bar, the chain pitch and the number of teeth on the bar tip sprocket. See instructions under the heading Technical data for information on the size of file and gauge that are recommended for the chain fitted to your chain saw. See instructions under the heading Lubricating the bar tip sprocket. € To prolong the life of the bar you should turn it over daily. (12) The chain is correctly tensioned when it does not sag from the underside of the bar, but can still be turned easily by hand. Hold up the bar tip and tighten the bar knob by turning the knob clockwise. Running-in Avoid running at a too high speed for extended periods during the first 10 hours. Two-stroke oil • For best results and performance use HUSQVARNA two-stroke engine oil, which is specially formulated for our air-cooled two stroke-engines. for guide bars of the same length , all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar. Recommended cutting equipment for Canada The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. for guide bars of the same length , all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar. Husqvarna must warrant the emission control system on your small nonroad engine for the period of time listed below provided there has been no abuse, neglect or improper maintenance of your unit. WARRANTY PERIOD Any warranted part which is not scheduled for replacement as required maintenance, or which is scheduled only for regular inspection to the effect of “repair or replace as necessary” shall be warranted for 2 years. [. . . ] Any warranted part which is scheduled for replacement as required maintenance shall be warranted for the period of time up to the first scheduled replacement point for that part. dIAGNOSIS The owner shall not be charged for diagnostic labor which leads to the determination that a warranted part is defective , if the diagnostic work is performed at an approved Husqvarna servicing dealer. CONSEQUENTIAL DAMAGES Husqvarna may be liable for damages to other engine components caused by the failure of a warranted part still under warranty. [. . . ]