Bruker manual PHILIPS MC-M250

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] ­ If you attempt to programme more than 40 tracks, "PROGRAM FULL" will be displayed. ­ If you press any of the CD DIRECT 1/2/3 buttons on the remote control, the system will play the selected disc or track, and the stored programme will be ignored temporarily. The PROGRAM symbol also will disappear temporarily from the display. It will reappear when playback of the selected disc ends. 1 17 3139 115 20742 pg 001-029/MC50-70/22-Eng 17 3/7/01, 2:23 PM English CD Operation English ­ During programming, if no key is pressed within 20 seconds, the system will exit the Programme mode automatically. To review the programme G Stop playback and press í or ë repeatedly. To erase the entire programme G Press Ç once when playback is stopped or twice during playback. "PROGRAM CLEARED" will be displayed. PROGRAM will disappear from the display. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. Shuffle All the available discs and their tracks or all the programmed tracks can be played in random order. 1 Press SHUFFLE on the remote control. G The discs and the tracks will be played in random order until you press Ç. 2 To resume normal playback, press SHUFFLE again. 2 Press and hold PROG until "AUTO" appears on the display. The system will search for all RDS stations and then continue with radio stations on FM, MW and LW band respectively. All available radio stations with sufficient signal strength will be stored automatically. The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. The last preset radio station or the first available RDS station will then be played when completed. To stop storing the automatic preset G Press PROG or Ç on the system. Note: ­ If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden. Manual Preset Programming 1 Press TUNER repeatedly to select the desired waveband : FM, MW or LW. The next available preset number will be displayed for selection. 3 Press and hold à or á until the frequency indication starts to change, then release. The display will show "SEARCH" until a radio station with sufficient signal strength is found. To store the radio station to another preset number G Press í or ë to select the desired preset number. [. . . ] ¶ You also can clean the heads by playing a cleaning tape once. CBAB C Demagnetising the heads ¶ Use a demagnetising tape available at your dealer. Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Problem CD OPERATION "NO DISC" is displayed. Solution ­ Insert a disc. [. . . ]